38478BA2B
8 27.5.08
Table of Contents Volume 1-7
5.4 Trouble Shooting ...................................................... 1 – 87
5.5 Replacing the Complete Uni-Probe .......................... 1 – 89
5.6 Replacing the Electronics Module ............................. 1 – 90
5.7 Replacing the Crystal-Multiplier Assembly................. 1 – 93
5.8 Replacing the Digital Board....................................... 1 – 94
5.9 Replacing the Power Supply Unit .............................. 1 – 96
5.10 Replacing Fuses ........................................................ 1 – 97
5.11 Updating the Embedded Software in the Uni-Probe.. 1 – 98
5.12 Scintillation Detector .............................................. 1 – 103
5.13 Customer Service.................................................... 1 – 106
5.14 Returning Repairs ................................................... 1 – 107
6 Certificates ..................................................................... 1 – 109
6.1 ATEX Certificate ..................................................... 1 – 109
6.2 FM Certificate......................................................... 1 – 121
6.3 CSA Certificate....................................................... 1 – 122
6.4 EG Declaration of Conformity................................. 1 – 124
7 Screw Fittings and Accessories ........................................ 1 – 125
7.1 ATEX Cable Screw Fittings ...................................... 1 – 125
7.2 ATEX-Adapter (Ex d IIC) for Screwed Cable Glands . 1 – 127
7.3 Dummy Plug........................................................... 1 – 127
7.4 Material Safety Data Sheet for Lubricant OKS 217 .. 1 – 128
8 Technical Drawings ......................................................... 1 – 131
8.1 Point Detector with Frontal Irradiation .................... 1 – 131
8.2 Point Detector with Lateral Irradiation..................... 1 – 132
8.3 Point Detector Mounting Clamps............................ 1 – 133
8.4 Sunscreen............................................................... 1 – 133
8.5 Point Detector Installation on a Container...............1 – 134
8.6 Holder Mounted on Uni-Probe................................ 1 – 134
8.7 Instructions for Installation of the Water Cooling .... 1 – 135
8.8 Required Amount of Cooling Water for Point
Detector ................................................................. 1 – 135
8.9 Point Source Shielding LB 744X .............................. 1 – 136
To Next Page
