EasyManuals Logo

Beta X-Trainer 300 2T User Manual

Beta X-Trainer 300 2T
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
2
OPERATION
24
GB
When using supplied power with the engine on:
•Theback-lightingisonpermanentlywhentheengineisrunning.
Using only the internal battery:
•WiththeLOsymbol,thebacklightingwillnotswitchon.Thesymbolappears
when the battery voltage is lower than 2.45V.
Reset Button:
Using the Reset button, located on the back of the instrument, all travel data will be
deleted, including date and time.
Internal battery:
The instrument houses a 3.0V internal button cell battery (CR2032). The instrument
can only work with this battery. The symbol appears when the battery is
running low. To change the battery, unscrew the cap located on the back of the
instrument using a coin.
Once the battery has been changed, make sure that the positive side is facing
outwards.
REPLACE THE BATTERY WITH ANOTHER CR2032-TYPE BATTERY.
2 SETTING THE PARAMETERS
General information:
Allowed settings:
•Km/h(kilometresperhour)orM/h(Milesperhour)
•Wheelsize(rollingcircumference)[mm]
•Clockformat:12-hour/24-hour
•Currentdate
•Maintenance
TO ENTER THE PARAMETER SETTINGS MODE HOLD DOWN THE RIGHT AND LEFT
BUTTONS FOR APPROX. 3s.
THE WORD “Unit” WILL FLASH ON THE DISPLAY.
The operational logic is structured as follows:
•TheinstrumententersSETUPmodedisplayingtheparametersaccordingtothe
sequence listed above.
•Theinstrumentdisplaystheparametertobechangedforafewsecondsinash
mode.
•Ifyouwish to change the parameter displayed for those few seconds simply
edit the values by pressing the right and/or left buttons (according to the modes
listed below), otherwise wait a few seconds (approx. 5 s) to proceed to the next
parameter.
•Whentheparameterhasbeeneditedtothedesiredvalue,theinstrumentau-
tomatically moves onto the next setting, there is no need to press any button of
confirmation.
•Ifyouonlywishtoenterthesetupmodetoviewtheconguredsettings,simplywait
without pressing any buttons; the instrument will display all of the set parameters
and will then automatically go back to “Normal Mode”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta X-Trainer 300 2T and is the answer not in the manual?

Beta X-Trainer 300 2T Specifications

General IconGeneral
BrandBeta
ModelX-Trainer 300 2T
CategoryMotorcycle
LanguageEnglish

Related product manuals