EasyManuals Logo

Beta X-Trainer 300 2T User Manual

Beta X-Trainer 300 2T
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
4
CHECKS AND MAINTENANCE
45
GB
Screw on filler cap 1 again.
WARNING:
Dispose of used oil in compliance with the
regulations in force.
LIQUID COOLANT
CHECK THE LEVEL
Keep the vehicle in vertical position relative
to the ground.
The level of the coolant must be checked
when the engine is cold. Use the following
procedure:
- Unscrew cap 1 and ensure that the liquid
is visible in the lower portion of the load-
ing tube.
- In the case in which the liquid is not visible
remove the vent screw 2 and proceed
topping up.
- At the end of operation refit the filler cap
and the vent screw.
Use the oil indicated on page 16in the
“Recommended lubricants and liquids” table.
WARNING:
Never unscrew the filler cap of the
radiator when the engine is hot.
Danger of burning!
1
2
2
1
15Nm
1
- Unscrew filler plug 1 and drain plug 2.
- Drain all the oil from the crankcase.
- Place the cap 2 and tighten to specified
torque.
Pour in the quantity of liquid indicated on
page 10.
Use the oil indicated on page 16 in
the “Recommended lubricants and liquids”
table.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta X-Trainer 300 2T and is the answer not in the manual?

Beta X-Trainer 300 2T Specifications

General IconGeneral
BrandBeta
ModelX-Trainer 300 2T
CategoryMotorcycle
LanguageEnglish

Related product manuals