EasyManuals Logo

Beta X-Trainer 300 2T User Manual

Beta X-Trainer 300 2T
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
2
OPERATION
31
GB
OIL MIXER REFUELLING
To refuel open the tank cap (page 18).
Fuel tank capacity is shown on page 10.
After refuelling, screw the cap back and tighten securely.
Use the oil indicated on page 16 in the “Recommended lubricants and liquids”
table.
STARTING THE ENGINE
Move the fuel tank valve in ON or RES position (page 18).
Check that the gears are in neutral (page 21).
Pull the clutch lever (page 19).
Close the side stand (page 21).
WHIT ELECTRIC STARTER (page 20):
Push the button until the engine starts.
Do not press the button while the engine is running.
COLD STARTING:
Operate the starter (page 19), start the vehicle, wait a few seconds, then move
the starter back to its starting position.
ENGINE SHUT-DOWN
To shut-down the engine press the button on the left switch unit (page 20).
NOTE:
With the engine off, make sure the fuel cock is set to OFF (page 18).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta X-Trainer 300 2T and is the answer not in the manual?

Beta X-Trainer 300 2T Specifications

General IconGeneral
BrandBeta
ModelX-Trainer 300 2T
CategoryMotorcycle
LanguageEnglish

Related product manuals