32
Not shown:
• Spare parts set
• These operating instructions
To order more CO
2
cartridges as well as original accessories and spare parts,
visit our website: www.service-shopping.de
Before Initial Use
Before you can use the beer pump, you must:
• unpack the items supplied,
• assemble the beer pump (see the "Preparation" chapter, "Setting Up and Assembling
the Beer Pump" section),
• clean the beer pump (see the "Cleaning" chapter).
Unpacking the Items Supplied
CAUTION!
Keep children and animals away from the packaging material. There is a danger of
suffocation!
• Unpack all parts and check the items supplied for completeness (see the "Items Sup-
plied and Device Overview" chapter) and transport damage. If you fi nd any damage
to the components, do not use them (!), but contact the customer service department.
• Remove any protective fi lms and stickers that may be present from the device.
Preparation
Purchase a 5 litre beer keg of your choice and allow it to rest for around two hours before
you use it to prevent excessive frothing when you tap into it.
Bear in mind that it can take around 15 hours for beer at a temperature of 22 – 24°C to
cool down to 2 – 10°C in the beer pump.
Cool the beer keg in the fridge fi rst to speed up the cooling process. This means
you also have the option of having a second beer keg on hand ready to be used
immediately.
Never cool beer kegs in a chest-type freezer! Cooling in a chest-type freezer
can cause beer kegs to burst. In addition, rapid chilling of beer results in a loss
of quality.
To Next Page
Loading...