3
Installation, Operation and Maintenance Manual
MAN616_EAC Rev. 5 July 2020
Section 1: General Warnings
General Warnings
1.3 Description of the Actuator
“ALGAS-QA” quick acting spring-return pneumatic low pressure actuators, are suitable for
the operation of quarter turn valves (ball valves, buttery valves, plug valves).
These actuators are suitable to achieve a very short time in emergency operation performed
by the spring, independently from the ow capacity of supply lines to the actuator.
In fact the quick operation is requires normally only to bring the valve to the “safe” position.
The operating time can be lower than one second, depending on the process
characteristics, valve size and operating pressure.
The actuator is made up of a weatherproof scotch yoke mechanism transforming the linear
movement of the pneumatic cylinder (or mechanical manual override, if foreseen) and of
the spring into the rotary movement, which is necessary for operation.
The pneumatic cylinder is tted with an integral “quick exhaust valve” directly assembled on
the end ange.
Furthermore the cylinder has a specic dumping system to gradually reduce the speed in
the last portion of the valve stroke, avoiding possible impact damages to the valve trim and
to the actuator itself.
The spring-return pack incorporates up to four springs, fully encapsulated in a factory
welded cartridge: this ensures safety to personnel and simplies assembly. The spring
action can be easily changed in the eld from to close in to open or from to open in to close
(modular design).
The angular stroke of the yoke is adjustable between 82° and 98° by means of the external
mechanical stops screwed into the end ange of the pneumatic cylinder and into the end
ange of the spring-return pack . The cover of the scotch yoke mechanism is arranged for
the assembly of the required accessories (position-transmitter, signaling-limit switches,
positioner, etc.) by means of proper matching units. The above mentioned accessories are
operated by the actuator drive sleeve.
The housing of the scotch yoke mechanism has a ange with threaded holes to x
the actuator to the valve either directly or, if required, with the interposition of an adaptor
ange or a mounting bracket.
The actuator yoke has a hole with keyways suitable for the assembly of an insert bush or a
stem extension. Their internal hole is machined (by BIFFI or at Customer's care), according
to the shape and dimensions of the valve stem.
BIFFI can supply different types of control system following Customer's requirements.
To Next Page
Loading...
Need help?
General
