Bilanciai D70A - Automatic Switch-Off

WARNING
The on or off key can be disabled during the
installation phase. In this case, the customer must install an
accessible disconnector.
This function is used when the terminal is installed in places
that are difficult to access (e.g. at a height of 3 m). In this
case, the terminal remains permanently on and the
disconnector must be used to switch it off.
4.3.1 Automatic switch-off
The terminal can be configured in the AUTOMATIC SWITCH-OFF mode
to optimize power consumptions. If the stable weight condition remains
for 5 minutes, the terminal switches off automatically.
A minute before switching off, the display begins to blink to inform the
operator about the imminent switch-off.
WARNING
Automatic switch-off will not occur when the batteries are
charging.
To enable this function, select value YES for the OFF parameter and
follow the instructions given in par. 5.9 on page 1-46.
D70
1-40