9.4.10 Scale zeroing
AZ<CR>
9.4.11 Tare acquisition
AT<CR>
9.4.12 Tare entering
nAT<CR>
The command AT must be preceded by a weight expressed in a
maximum of 7 characters comprising the decimal point, if present.
9.4.13 Cancellation of an entered tare
CT<CR>
This command cancels any tare value in the memory.
9.4.14 Request for transmission of the general data table
ND<CR>
When this command is transmitted, the terminal responds with a
sequence of strings terminating with <CR><LF>, each containing the
number of the data item and its description. An example of a table with
the data controlled is given below:
1 Auw
2 Pieces
3
Volt-0 / Curr-0
4
Volt.rf / Curr.rf
5
Wgt.ref
D70
1-74
To Next Page
Loading...
