Bilanciai D70A - Request for General Data Item Indicated with N; Request for Entry of the Y Value in the General Data Item Indicated with N; Request for Transmission of the Net Weight and the Scale Status

9.4.15 Request for general data item indicated with "n"
Xln<CR>
This command can be used to read the current value of any of the
general data items (if you are in the corresponding mode).
9.4.16 Request for entry of the "y" value in the general data
item indicated with "n"
yXln<CR>
where "y" is the value to be ascribed to general data item "n". The value
set must obviously be compatible with the format of the data item.
Entry of values for certain general data items (e.g. pieces) is not
allowed.
9.4.17 Request for transmission of the net weight and the
scale status
Xn<CR> (Xnb<CR>)
N.B.: the command sent is comprised of an uppercase X and lowercase
n (not to be confused with generic significance assigned to the
lowercase n described in par. 9.1 on page 1-61).
In the case of a positive reply, the terminal responds with the following
string:
n<SP><um><SP><s1><s2><s3><s4><CR><LF>
Characters s1, s2, s3 and s4 are status characters the meaning of which
is explained in par. 9.4.8 on page 1-71 while n is a numeric field of 9
characters.
D70
1-75