Bilanciai D70A - Default Chapter; Table of Contents

Table of Contents
1. GENERAL 1-7
1.1 Declaration of conformity 1-7
1.2 Foreword 1-8
1.3 Symbols 1-10
1.4 Description of the terminal 1-11
1.5 Technical characteristics of the terminal 1-12
1.6 Dimensions and weight of the terminal 1-13
1.7 How to dispose of electric or electronic waste 1-18
1.8 Obtaining technical assistance 1-19
1.9 Warranty 1-19
2. SAFETY INSTRUCTIONS 1-21
2.1 Prohibited uses 1-21
2.2 Regulations 1-21
2.3 Prescriptions of use 1-21
3. DELIVERY AND INSTALLATION 1-23
3.1 Connection of the terminal to the electrical supply line 1-25
3.2 Connection of the terminal to the platform scale 1-26
3.2.1 Connection of analogue load cells 1-27
3.3 COM1 serial port connection 1-28
3.4 COM2 serial port connection 1-30
3.4.1 Connection of COM2 in RS232 configuration 1-30
3.4.2 Connection of COM2 in RS422 configuration 1-31
3.4.3 Connection of COM2 in RS485 configuration 1-32
3.5 Analogue output connection (D70B version only) 1-34
3.6 Programmable analogue output 1-34
4. CONTROLS, DISPLAY, SWITCHING THE TERMINAL ON AND OFF 1-35
4.1 Display of weight and additional information 1-35
4.2 Description of the keys 1-37
4.3 Switching the terminal on and off 1-39
4.3.1 Automatic switch-off 1-40
5. USE OF THE TERMINAL 1-41
5.1 General 1-41
5.2 Entering numeric data (Editor) 1-42
5.3 Weight reset 1-43
5.4 Tare entry by acquisition 1-43
5.5 Tare entry via the keyboard 1-44
5.6 Tare display 1-45
5.7 Tare deletion 1-45
5.8 Weighing data print-out/transmission 1-45
5.9 Special Scale settings 1-46
5.10 EPC operating mode 1-48
5.10.1 AUW acquisition 1-48
5.10.2 Special PIECE COUNTER settings 1-50
6. OPTIONS 1-53
6.1 Internal battery connection option (version D70A only) 1-53
6.1.1 Recharging the internal batteries 1-54
D70
1-3