NO
No protocol enabled on the COM1 / COM2
serial ports.
TEMP
This parameter defines the timing for
transmission of the string selected by the
previous parameter.
RICH
Indicates that the string (CB and ESTESA) is
only transmitted when is pressed.
Moreover, if ESTESA is selected, the remote
commands for interrogation are activated.
CONT
Indicates that the string (CB or ESTESA) is
sent cyclically about 3 times a second. If the
string is ESTESA, the cyclic transmission can
be stopped by a suitable remote command.
ACKNAK
This parameter is only significant with the CB
type string. The string is only transmitted when
is pressed. After string transmission, the
terminal waits max. 3 seconds for acceptance
of the ACK or NAK character.
RS232, RS422, RS485
INTRF
(only COM2
sub-menu)
Defines the hardware interface used to
transmit the string.
D70
1-85
To Next Page
Loading...
