Binary B-500-MTRX-230-4x4 - IR Pass-Through Installation and Setup; Matrix Switcher IR Connections

B-500-MTRX-230-4x4 Installation Manual
Pg. 12
© 2013 Binary
™
7.8. IR Pass-Through Installation and Setup
ToutilizeIRpass-throughbetweenadisplaylocationandthematrixswitcher,installaB-500-RX-230-IRatthedisplay
anduseHDBaseTforroutingthesignal.Thematrixswitcherandthematrixreceiverareequippedwithportstoallow
commandstobesenttothedisplayorfromthedisplayarea.ThissectiondetailsthepinoutsandcorrectuseoftheIR
pass-through ports.
7.8.1. Matrix Switcher IR Connections
Theportsindicatedinthediagramaredescribedindetailbelow.Guidesforstandardapplicationsareincludedonthe
followingpagesforreferenceduringsetup.
7.8.2.MatrixSwitcherIRPortConguration
AllIRconnectionportsontheB-500-MTRX-230-4X4are3.5mmmonominiandusethispinoutconguration.Consult
withthemanufacturerofanyattachedIRequipmenttoconrmtheirpinoutmatchesbeforeuse.
IR Signal (Tip)
GND (Sleeve)
IR Signal Tip
GND (Ground) Ring
1. IR Output to Source 1 through 4
TheIRoutputfromeachconnectedB-500-RX-230-IRistransmittedtotheIROUTPUTTOSOURCEports.
Commandscanberoutedtothesourceselectedortothelike-numberedport.
2. IR Input to Room 1 through 4
 Use3.5mmmini-monocablestoconnectIRasheroutputsonacontrolsystemtotheseportstosendcommands
todisplaysorequipmentlocatedattheB-500-RX-230-IRmatrixreceiverlocation.Thenumbercorrespondstothe
outputzonenumber,soIRInputtoRoomport1willsendsignalstoHDBaseToutput1.
3. System All IR Out
 ThisportrepeatsanycommandsentfromtheIRReceiverportsonB-500-RX-230-IRMatrixReceiversconnected
to any HDBaseT output.
4. System IR In
 3.5mmmonominiIRinputportformatrixswitchIRcontrol.
LINK LINK LINK LINK
1 3
2 4
1 3
2 4
1 2 3 4