Binary B-500-MTRX-230-4x4 - Resetting to Factory Defaults

B-500-MTRX-230-4x4 Installation Manual
Pg. 23
www.snapav.com Support: 866.838.5052
11.1.4. Resetting to Factory Defaults
ThisprocedureresetstheB-500-MTRX-230tofactorydefaults:
• EDIDs-1080pStereo(embedded2)
• I/O-AllOutputssettoInput1
• 1CATEDIDscleared,DHCP-Enabled.
Reset Factory Defaults
Display Readout
(Example)
1.PressDEFAULT
E-
2.PressDEFAULT
--
3.PressDEFAULT
--
4.PressDEFAULT
DD
5.PressENTER
D-
Note: Resetting factory defaults can take up to 2 minutes to complete. Wait until the screen displays an output and input
selection of 1.1 before attempting further setup or use.