BINDOMATIC 301 DFS - Document Overview

20 Making the documents
Document overview
A document consists of one or more sheets, bound into a specially designed Bindomatic
cover. The covers are available in a variety of spine widths, cover types and colors ranging
from 1.5 mm (1/16 inch) to 13 mm (1/2 inch). The appropriate spine width for a document
depends on the paper weight and number of sheets being bound.
The number of sheets that can fit into a specified spine width varies according to the weight
of the paper. For 80 gsm or 20 lb, 24 lb paper, refer to the Spine Width/Sheet Capacity table
in chapter 7, ”Technical data”.
If the 301 DFS detects the use of a non-Bindomatic cover, a ”Please Feed Set Using an
Bindomatic Cover - Press Reset to Continue” message will appear in the Message Display
of the Control Panel of the 301 DFS. The 301 DFS will stop processing. You must perform
a jam clearance to remove the copy set and cover from the 301 DFS. See chapter 6, ”Problem
solving”, for further information about jam clearance.
The covers are contained in recyclable cardboard cassettes. Cassettes are packaged in cases
of three. Each cassette contains 150 covers.
The cassettes are loaded into the Cover Trays of the 301 DFS. Each cassette has a bar code
that the 301 DFS reads to determine the cover type, color, and spine width. This is the
information that appears in the Cover Supply Contents Display of the Control Panel of the
301 DFS.