BINDOMATIC 301 DFS - Inserting Additional Sheets into a Bound Document

Problem solving 59
Inserting additional sheets into a bound
document
Occasionally, you may wish to add sheets to a bound
document. The 301 DFS enables you to do so. You cannot,
however, remove pages from a bound document.
To add sheets to a bound document, perform the following
procedure:
WARNING: Do not exceed the capacity of the cover spine
width of the bound document. To determine the maximum
number of sheets, refer to set size reference chart in chapter 7,
”Technical data”.
WARNING: If you insert a new first or last sheet into the
bound document, the document may not bind properly.
1. Manually insert the sheet(s) into the bound document at
the appropriate spot(s).
• Tamp the sheet(s) into place as neatly as you can.
2. Open the Manual Feeder door.
3. Insert the bound document into the Manual Feeder.
NOTE: Follow the directions on the labels adjacent to the
Manual Feeder area of the 301 DFS for the correct
positioning of the document.
4. Select 1 & 2 (None) as the cover source from the Cover
Supply section on the Control Panel of the 301 DFS.
5. Press the Manual Start button on the Control Panel of the
301 DFS.
6. Retrieve the document from the Output Tray of the 301
DFS after the binding process has completed.
Note: Refer to chapter 3, ”Making the documents”, for
complete information about using the Manual Feeder.