74 Safety information
Instructions for safe use
The 301 DFS and its supplies have been designed and tested to meet strict safety
requirements. These requirements include examination and approval by a safety agency and
compliance with established environmental standards.
To make sure that the hardware operates safely, please adhere to the following safety
recommendations:
General safety
• The 301 DFS is heavy. Ensure that the floor is level and strong enough to support the
weight of the system.
• Do not place the 301 DFS near a heat source.
• Do not block or cover the openings on the 301 DFS.
• Place the 301 DFS in an area that provides adequate space for ventilation and
servicing.
• Follow all warnings and instructions marked on, or supplied with, the equipment.
• If the 301 DFS does not operate normally, refer to chapter 7, ”Problem Solving”.
• Disconnect interface cable when removed from printer.
Electrical safety
• Do not use an extension cord. Always connect the 301 DFS power cable directly into
a properly grounded power source receptacle. If in doubt, have the receptacle
checked by a qualified electrician.
• Do not use an adapter plug to connect the 301 DFS to an electrical outlet that lacks a
ground connection terminal.
• Never override or disable electrical or mechanical interlocks.
• Do not push objects into slots and openings on the 301 DFS. Making a contact with a
voltage point or shorting out a part could result in a fire or electrical shock.
• If you hear unusual noises or detect strange odors, switch off the 301 DFS power
immediately. Disconnect the power cord from the electrical outlet and call a
Bindomatic Service Representative to correct the problem.
• Do not place the 301 DFS where people may walk on the Power Cord or Interface
Cable Cord.
• Do not place objects on the 301 DFS Power Cord or Interface Cable Cord.
To Next Page
Loading...