Safety information 75
• Do not set containers of liquids on the Top Cover of the 301 DFS.
• Switch off the DFS10 Power Switch, disconnect the Power Cord, and call a
Bindomatic Service Representative when any of the following conditions occur:
- The Power Cord or plug is damaged or frayed
- Liquid is spilled into the DFS10
- Any part of the DFS10 is damaged.
Maintenance safety
• Do not perform any maintenance procedure that is not described in this Operator
Manual, or you have not been trained to do by an Bindomatic Service Representative.
• Do not remove any covers or guards that are attached with screws. There are no parts
that you can maintain or service behind these covers.
• Use the materials and supplies specifically designated for the DFS10. The use of
supplies that are not approved may cause poor performance and could create a
dangerous condition.
• Use the supplies and cleaning materials only as directed in this Operator Manual.
Keep all of these materials out of the reach of children.
To Next Page
Loading...