70 Technical data
Document cool-down time
The table below lists the recommended cool-down time for the glue in the document cover
spines to reach almost full strength. When the documents exit the 301 DFS, you can handle
and browse through them. You should not, however, allow them to lie open until the
recommended cool-down time.
The times indicated are for stacks of documents consisting of copy sets fed into the 301 DFS
from the host machine. Individual documents will cool down in approximately half the time
shown. Documents consisting of cooled-down copy sets fed through the Manual Feeder will
also cool down in half the time shown.
Spine width
(millimeters/inches)
Cool-down times
(in minutes)
1,5 (1/16) 10
3 (1/8) 15
6 (1/4) 25
9 (3/8) 35
13 (1/2) 45
To Next Page
Loading...