Introduction 3
Organisation and content of this manual
The Bindomatic 301 DFS Operator Manual contains the following chapters:
Chapter 1 Introduction
This chapter provides information on Bindomatic support for
service and supplies. It explains the organisation, content,
terminology, and conventions of this manual. It also contains
safety statements, provides information about the location of the
301 DFS, describes the product orientation, and lists additional
information sources.
Chapter 2 Getting to know the 301 DFS.
This chapter describes the main components of the 301 DFS and
illustrates the document path through the 301 DFS.
Chapter 3 Making the documents
This chapter provides an overview of documents and document-
making. It contains instructions for determining the correct spine
width, selecting the desired cover source, and loading cassettes.
Additionally, it describes the procedures for making documents in
both automatic and manual modes.
Chapter 4 Customizing your 301 DFS
This chapter describes the features you can set to customize your
301 DFS.
Chapter 5 Maintenance
This chapter provides helpful hints for the maintenance of the 301
DFS and for ordering supplies. It also contains instructions for
storing the cover cassettes and cleaning the 301 DFS.
Chapter 6 Problem solving
This chapter contains detailed procedures for resolving specific
problems with your 301 DFS, as well as a general problem-
solving table. For problems you are unable to resolve by using
this manual, it also explains the procedure for placing a call for
service.
Chapter 7 Technical data
This chapter contains the product and paper/cover specifications
for the 301 DFS. In addition, it contains the sheet capacities for
the various spine widths, a copy paper satisfaction guide, and the
document cool-down times.
To Next Page
Loading...