66 Technical data
Product specifications
The table below contains the product specifications for the 301 DFS.
Automatic operation The 301 DFS is shipped with a Third Party Enablement Kit. The
kit enables the 301 DFS to operate as an accessory to the host
machine. Each kit is for one host machine only. Additional host
machines require additional kits.
Binding speed Accepts approximately one copy set per 2 seconds
Document output time Approximately 2.0 minutes from the time of entrance of a copy set
into the 301 DFS until the document is available in the Output
Tray
Document capacity - On-line: 1 to 120 sheets (80 gram or 20 lbs paper)
- Manual: 1 to 120 sheets (80 gram or 20 lbs paper)
Output Tray capacity 20 to 80 documents depending on the spine width
Cover Tray capacity - Cover Tray 1: 1 cover cassette (150 covers)
- Cover Tray 2: 1 cover cassette (150 covers)
Warm-up time - From the Off position: Approximately 2 minutes
- From the Energy Saver mode: Approximately 2 minutes
Electrical requirements - Standard office outlet
- Europe: 230 VAC, 50 HZ
- North America: 115 VAC, 60 HZ
Environmental requirements - Minimum: 17° C (63° F) at 15% relative humidity
- Maximum: 32° C (90° F) at 85% relative humidity
Machine dimensions - Height to Output Tray: 965 mm (38 inches)
- Height to top of Output Tray cover: 1200 mm (48 inches)
- Depth: 597 mm (23 1/2 inches)
- Width with output height of sheets from host machine 860 mm
is 1450 mm
- Width with output height1021 mm is 1375 mm
Machine weight - Approximately 200 kg (440 lbs) with cassettes
Noise level - Run: 78 decibels
Power consumption - Warm up: 800 watts
- Operation: 324 watts
- Energy Saver: 31 watts
Heat output - Warm up: 2730 BTU per hour
- Operation: 1106 BTU per hour
- Energy Saver: 108 BTU per hour
To Next Page
Loading...