BINDOMATIC 301 DFS - Page 49

Customising your Bindomatic 301 DFS 43
Attention Lamp and Sound Tone
1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the New Job button until Lamp and Tone appears on
the second line of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Lamp and Tone.
4. Press the New Job button to display the desired Lamp setting.
NOTE: You can select ”enabled” or ”disabled”. Pressing the
New Job button enables you to switch between the two
choices.
5. Press the Manual Start button to display the desired Tone
setting.
NOTE: You can select ”enabled” or ”disabled”. Pressing the
Manual Start button enables you to switch between the two
choices.
6. Press the Stop button to save the settings and exit the Lamp
and Tone feature.
7. Do one of the following:
• Press the New Job button until the next feature you want to
change appears on the second line of the Cover Supply
Contents Display.
• Press the Reset button to exit the Customer Tools features.
Electronic Counter
1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the New Job button until Counter appears on the
second line of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Counter.
4. Press the New Job button to proceed with the Counter reset.
5. Press the New Job button again to confirm the Counter reset.
6. Press the Stop button to save the setting and exit the Counter
feature.
7. Do one of the following:
• Press the New Job button until the next feature you want to
change appears on the second line of the Cover Supply
Contents Display.
• Press the Reset button to exit the Customer Tools features.