Customising your Bindomatic 301 DFS 45
Software Version
1. Enter the Customer Tools mode as instructed in the previous
section of this chapter.
2. Press the New Job button until Software Version appears on
the second line of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Software Version.
NOTE: The software version level of the Main Board
EPROM and UI Board EPROM will appear in the Cover
Supply Contents Display. This information is read-only.
4. Press the Stop button to exit the Software Version feature.
5. Do one of the following:
• Press the New Job button until the next feature you want to
change appears on the second line of the Cover Supply
Contents Display.
• Press the Reset button to exit the Customer Tools features.
To Next Page
Loading...