54 Problem solving
Jam clearance procedures
Below are the procedures for clearing 301 DFS jams.
Area F9
To clear a jam in Area F1, do the following:
1. Read the instructions in the Message Display.
2. Use the Mimic Display to locate the jam.
3. Open the Set Collating Door.
4. Follow the instructions on the jam clearance labels inside
the Interface Module to remove the copy set and any
obstruction.
NOTE: Check any sheets removed from the 301 DFS for
damage and integrity. If the sheets are undamaged, save
them for manual processing into bound documents through
the Manual Feeder. For further information, refer to the
”Manual processing of sheets and covers removed during
jam clearance” section of this chapter.
WARNING: Close the Set Collating Door as soon as you clear
the jam. If you leave the door open too long, any documents
waiting in the Binder Module area will overheat. This will
result in defective binding and warped documents.
5. Close the Set Collating Door.
6. Read the instructions in the Message Display.
7. Follow the directions on the host machine User Interface
screen.
NOTE: Check any sheets removed from the host machine
for damage. If the sheets are undamaged, save them for
manual processing into bound documents through the
Manual Feeder. For further information, refer to the
”Manual processing of sheets and covers removed during
jam clearance” section of this chapter.
To Next Page
Loading...