BINDOMATIC 301 DFS - Page 67

Problem solving 61
A document jams when
manually fed into the 301
DFS for re-binding or
adding sheets.
The document has curled. Clear the jam as directed in
the ”Locating and clearing a
jam” section of this chapter.
Then insert the document
into the Manual Feeder
opposite to instructions on
the labels.
NOTE: This document
placement differs from the
instructions provided in
chapter 3, ”Making the
documents”. Follow this
procedure for resolution of
this problem only.
Binder displays a
message instructing you
to feed a set using an
Bindomatic cover.
A non-Bindomatic cover type is
being used.
The cover sensor cannot
detect the Bindomatic cover
because the cover is deformed.
Clear the jam as directed in
the ”Locating and clearing a
jam” section of this chapter.
Load a cover cassette
containing Bindomatic covers
into the selected Cover Tray
or insert a copy set with a
Bindomatic cover into the
Manual Feeder.
Clear the jam as directed in
the ”Locating and clearing a
jam” section of this chapter.
Straighten the cover spine.
Document Quality
Documents are bound on
wrong edge of copy sets.
Auto feed:
The documents were placed
incorrectly into the Document
Feeder of the host machine.
Manual feed:
The copy sets were fed
incorrectly into the Manual
Feeder of the 301 DFS.
Auto feed:
See the operator manual of
the host machine for correct
orientation of the documents.
Manual feed:
Insert copy sets into the
Manual Feeder as directed in
chapter 3, ”Making the
documents”.
Condition Causes Suggested solutions