___________________________________________________________________
Issue 02 - 04/2004 Libra S21/S22, English 13
Methods A (4), B (5) and C (6)
After defining parameters in any of the applications, and prior to measuring a
sample, a method can be saved. To save a method:
• press stop to return to the home page
• select one of the three method banks (4, 5, or 6)
• press save (F1) and choose an unfilled method by pressing the appropriate number
• enter the method name (see below) and press OK (F3)
A stored method is available as an option directly on the instrument menu.
To change parameters, the method must be deleted first. To delete a method:.
• press stop to return to the home page
• select one of the three method banks
• press delete (F2) and select the required method by pressing the appropriate
number; you are asked to confirm this.
Entry of alphanumeric characters for print outs and method names
• Remove default characters, if necessary, using ←
• Press appropriate key on keypad to cycle through options of lower case letter,
numbers and upper case letters (for example pressing key 2 cycles through
abc2ABC). Note that a space is entered using key 1, which cycles between
1_1_)
• Press another key to move to next letter. To enter a doubled letter (eg AA) or
number (eg 00), press > (F2) and then the appropriate key again.
• Delete incorrect characters using ←
• Complete entry by pressing OK (F3)
• An example of name entry is given in the Appendix.
To Next Page
Loading...
