___________________________________________________________________
Issue 02 - 04/2004 Libra S21/S22, English 23
Cleaning and General Care
External cleaning
• Switch off the instrument and disconnect the power cord.
• Use a soft damp cloth.
• Clean all external surfaces
• A mild liquid detergent may be used to remove stubborn marks.
• Sample compartment spillages
• Switch off the instrument and disconnect the power cord.
• The cell holders, baseplate and sample compartment are all coated in a chemical
resistant finish. Strong concentration of sample, however, may affect the
surface, and spillages should be dealt with immediately.
• Observe all necessary precautions if dealing with samples or solvents that are
hazardous.
• There is a small drain hole in the sample compartment to allow excess liquid to
drain away. Liquids will drain onto the bench or table under the
spectrophotometer or if preferred, this drain hole can be connected to waste
using suitable tubing.
• Remove the cell holder and clean separately.
• Use a soft dry cloth to mop out the sample compartment. Replace the cell
holder.
• Reconnect the power cord and switch on the instrument
.
To Next Page
Loading...
