___________________________________________________________________
Issue 02 - 04/2004 Libra S21/S22, English 19
Single Cell Holder Accessories
•
Install by removing accessory in place, replacing, if necessary, the baseplate
plug supplied and positioning the single cell holder so that the arrow is on the
front face and it locates in place. Then push the finger locks backwards so that
they lock into position. Press the accessory button on the home page
Description Part number Comments
Cell holder, 10mm pathlength 80-2106-05
Cell holder, for sample stirring 80-2108-10
Requires magnetic flea and controller
Cell holder, 50mm pathlength 80-2106-07
Cell holder, 100 mm
pathlength
80-2107-14
Cylindrical cell holder 80-2106-10
Up to 100 mm pathlength cylindrical
cells
Water heated cell holder 80-2106-08
10-40 mm pathlength.
Requires a water-circulating bath..
Replace the front blanking plug on
the cell compartment lid with the new
one that is provided..
HPLC cell holder 80-2106-11
Flowcell volume is 8 µl, pathlength is
2.5mm. Thread wires through one
hole of the tube guide and attach this
to the instrument base using the
screws provided. Replace the front
blanking plug on the cell
compartment lid with the new one
that is provided.
Peltier cell holder 80-2106-13
Set required temp in range 20-49 °C.
Insert into socket 2.
Electrical cell holder 80-2106-12
Set required temperature: off, 25, 30,
37 °C. Insert into socket 2.
To Next Page
Loading...
