Biosite Triage Meter Pro - Page 16

Rev AN-6
6. Change Clock:
a. Select SET PARAMETERS using the keys and Press the key.
b. Select
CLOCK using the keys and Press the key.
c. Select the HOUR : MINUTE area using the keys. Type in the correct time
using the number keys.
d. Press the key to move to
AM or PM.
e. Select AM or PM using the keys.
f. Press the key to move to
TIME FORMAT.
g. Select AM/PM or 24 HR. using the keys. If selecting 24 HR.,
the previously entered HOUR : MINUTE will change to a 24-hour format and
the AM or PM will disappear.
h. Press the key to move to the
DA
TE
.
i. Type in the 6-digit date according to the DATE FORMAT below it.
j. Press the key to move to the
DATE FORMAT.
k. Select MM-DD-YY, DD-MM-YY or YY-MM-DD using the keys.
The previously entered DATE changes as the DATE FORMAT changes.
l. Press the key to save changes.
Setting Default Options New Setting
TIME FORMAT AM / PM AM / PM; 24HR.
DATE FORMAT MM-DD-YY MM-DD-YY,
DD.MM.YY,
YY-MM-DD
7. Set User ID:
The Triage MeterPro normally requires a User ID to be entered prior to a patient test or
a QC test. Refer to page N-21 for instructions. Alternately, this feature may be
bypassed. See page N-8.
For more details about
Clock Settings see
page N-20.