Rev A O-7
PA
TIENT
SA
MPLE
1
. Press the key to power The Triage
®
M
eterPro on.
2. Select RU
N
TE
ST
using keys.
3. Press the key.
4. Type or scan in your identification number (User ID). To correct, press the key
to clear the entire number, or select the incorrect digit by using the
keys then type in the correct number.
5. Press the key.
6. Select
PATIENT SAMPLE using keys.
7. Press the key.
8. Type or scan the patient’s identification number (Patient ID). To correct, press the
key to clear entire number or select the incorrect digit using
then type in the correct number.
9.
Press the key.
MAIN MENU
RUN TEST
Note: If the
Bar Code
Scanner is being
used, simply point
the scanner at the
bar code, press the
button on the scanner
handle and wait for
the beep. The number
will appear on the
display.
Note: If the
User ID bypass
is
ON, the meter will
not ask you to enter a
User ID.
Menu scr
een as it looks when operator
selects Patient Sample.
The Main Menu
To Next Page
Loading...
