BP-007 User’s Manual
- 47 -
ESC G Turn double-strike mode on/off
Format: ASCII: ESC G n
Decimal: 27 71 n
Hex: 1B 47 n
[Description]
When double-strike mode is turned on, the same character will be printed twice in the same position.
• When n is 0, double-strike mode is turned off.
• When n is 1, double-strike mode is turned on.
ESC J
Print and feed paper
Format: ASCII: ESC J n
Decimal: 27 74 n
Hex: 1B 4A n
[Description]
Print the data in the print buffer and feeds the paper by n/144 inch. If there is no content in buffer, the printer
will feed paper directly without printing.
ESC K Print and feed reversely
Format: ASCII: ESC K n
Decimal: 27 75 n
Hex: 1B 4B n
[Description]
Print the data in the print buffer and feeds the paper by n/144 inch in the reverse direction.
n＝0~48.
ESC U Turn unidirectional printing mode on/off
Format: ASCII: ESC U n
Decimal: 27 85 n
Hex: 1B 55 n
[Description]
Turn unidirectional print mode on or off. n＝0~255, only the lowest bit is valid.
When n＝＜*******1＞B, unidirectional printing mode is set.
When n＝＜*******0＞B, bidirectional printing mode is set.
[Default] n = 0.
ESC c 4 n Select paper sensor to stop printing
Format: ASCII: ESC c 4 n
Decimal: 27 99 52 n
Hex: 1B 63 34 n
[Description]
Select the paper sensor to stop printing when a paper end is detected.
n=0~255.
n=05H, selects the paper sensor to stop printing when a paper end is detected.
n=0, when a paper end is detected, printing is not stopped, so that user can print the last bill to the page
end.
[Default] n = 05H.
To Next Page
Loading...
