BK Precision 5492 - Parameter; Explanation

85
7-5-3 SCPI Command Summary
Command Parameter Std/New Explanation
ABOUT Std Event, no query
CONFigure[:SCALar] Std
Configure meter to perform specified
measurement.
:CURRent
New Set the current measurement mode.
:AC
[<numeric value>]
[[,@1]|,@2]
New
:ACDC
:DCAC
[<numeric value>] [,@1] New
:DC
[<numeric value>]
[[,@1]|,@2]
New
:DIOCtest
New
Set the primary display to diode with the
continuity test.
:DISPlay
New Set and query the measurement rate type.
:RATE
<SLOW|MED|FAST> New
:RATE?
New
:FREQuency
[<numeric value>]
[[,@1]|,@2]
New Set the meter to frequency measuring.
:FUNCtion?
[[,@1]|,@2] New
Query the measurement function.
:OFFDual
New Turn off the 2ND display.
:OFFRecord
New Turn off the dynamic recording mode.
:RANGe
Std Set the measurement range.
:AUTO
<Boolean>[[,@1]|,@2] New
:AUTO?
[[,@1]|,@2] New
:DIRection
<UP|DOWN>
[[,@1]|,@2]
New
:RANGe?
[[,@1]|,@2] New
Query the measurement range.
:RESistance
New Set the resistance measurement mode.
[:2W]
[<numeric value>]
New
:4W
[<numeric value>]
New
:VOLTage
New Set the voltage measurement mode.
:AC
[<numeric value>]
[[,@1]|,@2]
New
:ACDC
:DCAC
[<numeric value>] [,@1]
New
:DC
[<numeric value>]
[[,@1]|,@2]
New