vi
Do not short-circuit batteries
When using a DC load to discharge a battery, do not exceed the battery manufacturer's
specified maximum rate of discharge.
Use correctly sized wires
To connect the load to the power supply, use a wire diameter large enough to handle the
maximum continuous output short-circuit current of the power supply without the wire
overheating.
For continued safe use of the instrument
Do not place heavy objects on the instrument.
Do not obstruct cooling air flow to the instrument.
Do not place a hot soldering iron on the instrument.
Do not pull the instrument with the power cord, connected probe, or connected test
lead.
Do not move the instrument when a probe is connected to a circuit being tested.
To Next Page
Loading...
Need help?
General
