40
4. The display prompts the user to enter the number of times to repeat the program (list).
For this example, enter 5 with the numeric keypad and then press .
Note: The maximum number of repeat times is 65535 times.
5. The next display will show the following:
6. This is similar to step 5 and 6 in the previous section for Configure Sequence
Parameters. Each of the numbers on the display represents the sequence numbers
stored in memory, with “0” representing sequence # 10.
7. In this example, only sequence #1 and sequence #2 will be executed. Therefore, use the
numeric keypad and press 1 and 2 so that both of those numbers on the display will
toggle to “Y” in their places like the following:
8. Once these two sequences are selected (active), press to see the following:
To Next Page
Loading...
Need help?
General
