MNS-BB Software User Guide
-90-
Note: Starting VLAN(s) will put them in active state.
To stop a VLAN use the following command:
LE2425A(tag-vlan)##stop vlan=<all|name|number|list|range>
where,
vlan is the name or VLAN ID which is to be stopped.
This field also accepts range of VLAN ID values. To stop all the ‘active’ VLAN’s, use ‘all’
instead of VLAN ID’s or VLAN name.
Note: Stopping VLAN(s) will put them in pending state.
To set the ingress for a set of ports use the following command:
Note: If you are setting Ingress or Egress rules remotely (Telnet, SNMP etc), then please start the
Vlan first. Otherwise, you would lock out yourself from the Vlan.
LE2425A(tag-vlan)## set-ingress port=<number|list|range> vid=<number>
action=<enable|disable>
where,
port is valid range/list of ports or a single port.
pvid is the valid Port VLAN ID. Its value can be between 1 and 4095.
action is used to enable or disable ingress on that set of ports.
To set the egress rules for a set of ports in a particular TAG VLAN use the following command:
LE2425A(tag-vlan)## set-egress vlan=<number> port=<number|list|range>
status=<tagged|untagged>
where,
vlan is the VLAN ID whose ports egress value has to be changed.
port is the port or list/range of ports who are members of the VLAN ID mentioned above.
status is the egress status for the ports. It can be either tagged or untagged.
To see the list of VLAN’s use the following command.
LE2425A(tag-vlan)##show vlan type=<port|tag|mac> [<id=vlanid>]
where,
type is the type of VLAN, here it has to be tag.
Id is optional, and is used to see information about a particular VLAN, if this field is not
entered, the entire list of TAG based VLAN’s is shown.
Note: VLAN’s that are still pending don’t have their egress setting set in the hardware. Only when
the VLAN is activated, the egress settings are set in the hardware. Hence to see the list of ports which
are set to tagged use the ‘show-egress’ command because show vlan will only show ports whose
egress settings are set in the hardware.
To see the ports and their ingress values use the following command:
LE2425A(tag-vlan)## show-ingress [ports=<number|list|range>]
ports is the port or list/range of ports whose ingress value has to be shown. This field is optinal and if
it is not entered, the entire list of ports and their respective ingress values are shown.
To see the ports which are tagged (whose egress values are set or to be set) use the following
command:
LE2425A(tag-vlan)## show-egress
Note: Egress settings are updated only when the VLAN is set to active state; hence, this command
shows the list of ports, which are set to egress, and their corresponding VLAN state. VLAN’s that are
still in pending state do not have their egress set in the hardware.
16.5 New CLI
The set-ingress, set-egress, show-ingress and show-egress commands are deprecated. Two new
commands viz. set-port and show-port take their place.
LE2425A(tag-vlan)##set-port
To Next Page
Loading...
