MNS-BB Software User Guide
-2-
Below is an example of the above prompt.
Below is the sequence of activities that must be completed for the network to find your switch.
1. Boot up the switch.
2. Set the Manager Password (optional).
3. Configure the IP Address and enter the IP address that is compatible with your network.
4. Configure the Subnet Mask and enter the subnet mask used for your network.
5. Configure the Default Gateway of your Network.
Syntax: ipconfig [ip=<ipaddress>] [mask=<subnet-mask>] [dgw=<gateway>]
Example: ipconfig ip=192.168.1.150 mask=255.255.255.0 dgw=192.168.1.10
6. Save
7. Restart the unit.
Note: Soft reboot given an opportunity to save the configuration prior to shutdown.
LE2425A#reboot
Proceed on rebooting the switch? [ 'Y' or 'N' ]Y
Do you wish to save current configuration? [ 'Y' or 'N' ]
The switch is now configured with a Manager Password, IP address, and subnet mask, and can be
accessed through the Console, Telnet, Web or an SNMP-based network management tools. Here is
some information about the basic fields.
Parameter Default
System Name LE2425A/LEV2525A Optional;
System Contact techsupport@blackbox.com Optional;
Manager Password manager Recommended;
Logon Default CLI The default setting;
Time Zone 0 (none) Optional;
Community Name (Get) public Default setting recommended;
Community Name (Set) private Default setting recommended;
Default Gateway blank Optional;
IP Address blank Recommended;
Note: The IP address and subnet mask assigned for the switch must be compatible with the IP
addresses used in your network. For more information on IP addressing, see the Chapter 5.
1.5 To Recover from a Lost Manager Password:
If you cannot start a console session at the manager level because of a lost Manager password, please
contact techsupport@blackbox.com
.
To Next Page
Loading...
