MNS-BB Software User Guide
-67-
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Disabled
Querier : Disabled
Querier Interval : 127
Querier Response Interval : 10
12.13 Setting the Query Response Interval
The query response interval is the maximum amount of time that can elapse between when the querier
router sends a host-query message and when it receives a response from a host.
Note: The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions apply
to the maximum value because of an internal calculation that is dependent on the value of the Query
Interval.
Syntax: set-qri interval=<value>
LE2425A(igmp)##set-qri interval=11
Query response interval successfully set
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Disabled
Querier : Disabled
Querier Interval : 125
Querier Response Interval : 11
Every port can be individually set to three different IGMP modes (please see section “Showing IGMP
Port Mode”). To set port mode, you use the command “set-port” in the IGMP command context.
User can use the console to configure individual ports to any of the following states:
Auto/Blocked/Forward (As described above in IGMP Operating Features).
• Auto – lets IGMP control whether the port should or should not participate sending multicast
traffic
• Block – manually configures the port to always block multicast traffic
• Forward – manually configures the port to always forward multicast traffic
12.14 Configure IGMP Port Mode
Syntax: set-port port=< port|list|range>> mode=<auto|forward|block>
LE2425A(igmp)##set-port port=1-2 mode=forward
Port mode is set.
12.14.1 Showing Port Configuration
To view the current setting of Ports in respect of IGMP.
To Next Page
Loading...
