Black Box LEV2525A - 12.11.6 Enable;Disable Switch as Querier; Setting the Host Membership Query Interval

MNS-BB Software User Guide
-66-
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Enabled
Querier : Enabled
Querier Interval : 125
Querier Response Interval : 10
LE2425A(igmp)##set-leave disable
IGMP immediate leave status is disabled
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Disabled
Querier : Enabled
Querier Interval : 125
Querier Response Interval : 10
12.11.6 Enable/Disable Switch as Querier
To enable or disable a switch as IGMP querier, use the command “set-querier” in the IGMP
command context.
Syntax: set-querier <enable|disable>
LE2425A(igmp)##set-querier enable
IGMP querier status is enabled
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Disabled
Querier : Enabled
Querier Interval : 125
Querier Response Interval : 10
LE2425A(igmp)##set-querier disable
IGMP querier status is disabled
LE2425A(igmp)##show igmp
IGMP State : Enabled
ImmediateLeave : Disabled
Querier : Disabled
Querier Interval : 125
Querier Response Interval : 10
12.12 Setting the Host Membership Query Interval
The IGMP querier router periodically sends general host-query messages. These messages are sent to
ask for group membership information. This is sent to the all-system multicast group address,
224.0.0.1.
Note: The default value is 125 seconds. The valid range can be from 60 to 127 seconds.
To set the value, use the command “set-qi” in the IGMP command context.
Syntax: set-qi interval=<value>
LE2425A(igmp)##set-qi interval=127
Query interval successfully set