MNS-BB Software User Guide
-73-
LE2425A(stp)##stp enable
Successfully set the STP status
LE2425A(stp)##show stp config
STP Configuration:
Spanning Tree Enabled(Global) :YES
Spanning Tree Enabled(Ports) :YES, 1,2,3,4,5,6,7,8
Bridge Priority :32768
Bridge Forward Delay :15
Bridge Hello Time :2
Bridge Max Age :20
Root Port :1
Root Path Cost :100
Designated Root :80:00:00:01:96:ed:a7:80
Designated Root Priority :32768
Root Bridge Forward Delay :15
Root Bridge Hello Time :2
Root Bridge Max Age :20
To disable STP, just issue the command stp disable under the STP CLI context.
To enable/disable STP by ports, the port port=<number|list|range> status=<enable/disable> is
used. An example shows below.
LE2425A(stp)##show stp config
STP Configuration:
Spanning Tree Enabled(Global) :YES
Spanning Tree Enabled(Ports) :NO
Bridge Priority :32768
Bridge Forward Delay :15
Bridge Hello Time :2
Bridge Max Age :20
Root Port :0
Root Path Cost :0
Designated Root :80:00:00:20:06:25:00:62
Designated Root Priority :32768
Root Bridge Forward Delay :15
Root Bridge Hello Time :2
Root Bridge Max Age :20
LE2425A(stp)##port port=1-8 status=enable
Successfully set the STP status for port 1
Successfully set the STP status for port 2
Successfully set the STP status for port 3
Successfully set the STP status for port 4
Successfully set the STP status for port 5
Successfully set the STP status for port 6
Successfully set the STP status for port 7
Successfully set the STP status for port 8
LE2425A(stp)##show stp config
STP Configuration:
Spanning Tree Enabled(Global) :YES
Spanning Tree Enabled(Ports) :YES, 1,2,3,4,5,6,7,8
Bridge Priority :32768
Bridge Forward Delay :15
Bridge Hello Time :2
To Next Page
Loading...
