MNS-BB Software User Guide
-81-
Please see the Note on Path Cost on page 14-15 for information on compatibility with devices
running 802.1D STP for the path cost values.
point-to-point(p2p) Auto
This parameter is used to tell the port if it is connected to a point-to-point link . Default parameter is
auto and the switch will automatically set the force-false value on all ports that it detects are not
running at full duplex. All connections to hubs are not full duplex.
You can also set this parameter to ON, such as to another switch or bridge or to an end node (force-
true).
This parameter should be set to OFF (force-false) for all ports that are connected to a hub, which is a
shared LAN segment.
priority 128
This parameter is used by RSTP to determine the port(s) to use for forwarding.The port with the
lowest number has the highest priority.
The range is 0 to 240, but you configure the value by entering a multiple of 16. You enter a value in
the range 0 - 15. The default value of 128.
To Next Page
Loading...
