Bluetooth function
43
Switching visibility on/off
For the Bluetooth connection, the navigation de-
vice must be visible to other Bluetooth-ready de-
vices.
Touch the symbol to switch the visi-
bility on (check mark) or off (no
check mark).
Paired devices
All registered cell phones are listed in the Paired
Devices menu and can be edited.
Prerequisite:
Bluetooth function and visibility in the cell
phone are activated
Note:
The Bluetooth connection can be established
only to one cell phone. If additional ones are
available, only the cell phone registered last
is connected.
Touch the symbol.
The Paired Devices menu is dis-
played.
Touch a cell phone in the list.
Touch the Options button.
Touch the symbol to establish the
Bluetooth connection.
Touch the symbol to disconnect the
Bluetooth connection.
Touch the symbol to rename the cell
phone in the list.
Touch the symbol to delete the cell
phone from the list.
Touch the symbol to delete all cell
phones.
쏅
•
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Ringtone
Touch the symbol.
The User Ring Tone menu is dis-
played.
Touch the desired ringtone.
Press the VOL - or VOL + button to adjust the
volume.
Establishing the connection automatically
If you switch off the device, the Bluetooth connec-
tion is disconnected. The automatic connection
causes the devices to be reconnected as soon as
the device is switched on again.
On the second page of the Bluetooth
Settings menu, touch the symbol to
allow the automatic connection
(check mark) or to prevent it (no
check mark).
Changing the PIN
If you want to connect devices with each other via
Bluetooth, you are requested to enter a PIN. By
default, this PIN is "0000", but it can be changed.
Touch the symbol.
The Change PIN Code menu is dis-
played.
Enter a new PIN of your choice via the key-
board.
Touch the OK button.
RAS settings
Access to the Internet with the navigation device
(ch. "Internet function") requires a modem. To use
your cell phone as a modem, confi gure the access
in the navigation device.
Note:
Note that the cell phone for an Internet con-
nection must be connected using the "DUN"
Bluetooth profi le (Dialup Networking Profi le)
(ch. "Registering with the navigation de-
vice").
쏅
쏅
쏅
쏅
쏅
쏅
쏅
To Next Page
Loading...
