H-80 Series User Manual V1.0
7 / 46
7. Glossary
Auto Off
When this feature is enabled, the device automatically stops outputting flow after the patient
removes the nasal cannula.
Delay
After pressing the stop button, the device stops outputting after continuing to work with the
flow of not more than 60 L/min for about 90min.
Standby
When this feature is enabled, the patient removes the nasal cannula, the FiO
2
drops to
21%(not applied to H-80M), the flow drops to below 40 L/min, it continues to heat, and the
temp of the output gas of the patient does not exceed 43°C, the maximum standby time is
30 min.
Warm-up time
When the flow is 40 L/min and starting temperature 23±2°C, the set temp of 29°C can be
reached within 10 min, the set temp of 37°C can be reached within 30min.
LCD Backlight
LCD Backlight can set the two modes. In backlight mode, the backlight is always on; in
automatic mode, the backlight can be dimmed for about 30 seconds without button
operation, and brightened when there is a button operation.
Trend Chart
The data of temperature, flow, FiO
2
and respiratory rate for 1 day, 3 days, and 7 days can be
reviewed.
LPM
Liters Per Minute.
RR
Respiratory Rate. Number of breaths per minute.
min
Means the time unit ―minute‖.
h
Means the time unit ―hour‖.
yy mm dd / mm dd yy / dd mm yy
Denotes date.
To Next Page
Loading...
Need help?
General
