H-80 Series User Manual V1.0
16 / 46
(4) Close the cover of water chamber: Close the cover of water chamber along the
direction shown in the Fig. 11-9, and buckles on both sides of the cover of water chamber will
be stuck in the slot of corresponding position of the device.
Fig. 11-9
WARNINGS!
• In order to prevent scalds, please do not start the device before installing the water
chamber.
• The water chamber will be heated in working, so please power off until the water chamber
is cooled and then take it out.
• If the device needs to be moved, the water in the water chamber should be drained off,
and it is prohibited to tilt the water chamber for fear of water flowing into the device.
• Please immediately replace the water chamber if it is damaged.
• The water chamber adapter is one-time use of accessory for use by single patient only.
• Do not use the water chamber if it has been run dry.
CAUTIONS!
• The humidifying effect can reach to optimum after preheating under room temperature
condition for above half an hour.
• The information of alarming journal will be maintained when the device is powered down,
but the instantaneous time of power down will not be recorded.
11.6 Connecting the water bag
Hang the sterile water bag above the device and insert the water inlet needle into the
injection hole under the water bag. As shown in Fig. 11-10. Open the air inlet cover beside
the needle and the water chamber will start to automatically add water to the fixed water
level.
Fig. 11-10
To Next Page
Loading...
Need help?
General
