In the multifunction display, L-
CON and the remaining number
of available starts 1 using Launch
Control are shown.
Start with Launch Control is pos-
sible.
Start as described below.
If no start using Launch Control
is currently possible, the number
0 is shown, alongside an exclam-
ation mark 2.
Allow the clutch to cool.
Cooling period for the
clutch
approx. 3 min (when the en-
gine is running)
approx. 20 min (when the en-
gine is not running)
Proceed in the normal way
when starting; open the throttle
only as far as necessary to
reach the rpm limit.
After engaging the clutch, open
the throttle completely.
If the DTC warning light
shows, the DTC system
has been switched off.
Shift light on.
Launch Control controls ideal
torque at the rear wheel and
maintains a constant engine
speed up to approx. 60 km/h.
As soon as rpm limitation
ceases, engine rpm increases
because the throttle twistgrip is
in the full-throttle position.
6
105
z
On the race track
To Next Page
Loading...
