Possible cause:
The number-plate carrier has
been removed; the motorcycle's
on-board electronics know that
the flashing turn indicators are
not installed on the motorcycle.
Installing number-plate carrier
( 108).
In SETUP mode, switch on
suppression of the error mes-
sage.
Motorcycle dropped
! VDS (Vertical Down Sensor)
appears on the blank display.
Possible cause:
The drop sensor has detected a
drop and has cut out the engine.
Bring the motorcycle to the
upright position
Switch the ignition off and
then on again or switch the kill
switch on and then off again.
Drop sensor defective
! VDS (Vertical Down Sensor)
appears on the display.
Possible cause:
A defect in the drop sensor has
been detected.
Seek the advice of a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
ABS self-diagnosis not
completed
ABS warning light flashes.
Possible cause:
The ABS function is not
available, because self-
diagnosis did not complete. The
motorcycle has to move forward
a few metres for the wheel-
speed sensors to be tested.
Pull away slowly.
Self-diagnosis is in progress.
The ABS function is available
when self-diagnosis completes.
ABS deactivated
ABS warning light flashes.
Possible cause:
The rider has switched off the
ABS system.
Activating the ABS function
( 44).
ABS fault
ABS warning light flashes.
Possible cause:
The ABS control unit has detec-
ted a fault. The ABS function is
not available.
You can continue to ride the
vehicle, but make due provi-
sion for the fact that the ABS
function is not available. Bear
in mind the more detailed in-
formation on situations that can
lead to an ABS fault ( 118).
Have the fault rectified as
quickly as possible by a
3
29
z
Status indicators
To Next Page
Loading...
