Starting
Starting engine
Switch on the ignition.
Pre-Ride-Check is performed.
( 64)
ABS self-diagnosis is in pro-
gress. ( 65)
DTC self-diagnosis is in pro-
gress. ( 65)
Select neutral or, if a gear is
engaged, pull the clutch lever.
You cannot start the mo-
torcycle with the side stand
extended and a gear engaged.
The engine will switch itself off
if you start it with the gearbox in
neutral and then engage a gear
before retracting the side stand.
When starting a cold engine
at low ambient temperatures:
disengage the clutch and turn
the twistgrip slightly to open
the throttle.
Press starter button 1.
The start attempt is auto-
matically interrupted if bat-
tery voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
See the subsection on jump
starting in "Maintenance" for
more details.
The engine starts.
Consult the troubleshooting
chart below if the engine re-
fuses to start. ( 168)
Pre-Ride-Check
The instrument panel runs a test
of the warning lights and the re-
volution counter when the igni-
tion is switched on: this is the
Pre-Ride-Check. The test is
aborted if you start the engine
before it completes.
Phase 1
Telltale and warning lights light
up, 'General' warning light shows
yellow.
The needle of the revolution
counter moves all the way to the
position for maximum engine re-
volutions.
All the segments in the display
light up.
Phase 2
The 'General' warning light
changes from yellow to red.
5
64
z
Riding
To Next Page
Loading...
