Alarm signal
The alarm signal continues for
26 seconds. The system is act-
ive again another 12 seconds
later. You can interrupt an alarm
signal at any time by pressing
button 1 on the remote control.
This function does not change
the status of the anti-theft alarm.
While an alarm is in progress an
acoustic alarm signal sounds and
the turn indicators flash. You can
program the type of alarm signal.
Deactivation
with anti-theft alarm (DWA)
OE
Kill switch in operating position
(run).
Switch on the ignition.
Turn indicators flash once.
Confirmation tone sounds once
(if programmed).
Anti-theft alarm (DWA) is deac-
tivated.
DWA adjusting
with anti-theft alarm (DWA)
OE
Switching on ignition ( 34).
Repeatedly short-press
SET 2 until SETUP MENU
ENTER 3 appears on the
display.
If you scroll down too far,
repeatedly short-press
SET 2 until the menu returns to
the start and then to the reading
you want.
Long-press SET 2 to open the
menu.
4
36
z
Operation
To Next Page
Loading...
