V00G01Y
TRAXTER MAX 5 SPEED
1. Ignition system
2. Accessories (power outlet and
auxiliary supply)
3. Solenoids
4. Fan
5. MPEM (Multi-Purpose Electronic Module)
6. Charging system
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
A15E0KY
1
2
TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch
OFF before replacing a defective
bulb.
Always check light operation after re-
placement.
Headlamps
CAUTION:
Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating life.
If glass is touched, clean it with iso-
propyl alcohol which will not leave
a film on the bulb.
Unplug connector from headlamp.
V04G02Y
Rotate the bulb socket counterclock-
wise then remove headlamp.
V04G03Y
1 2
1. Unlock
2. Lock
_____________________
137
To Next Page
Loading...
Need help?
General
