bora GP4 User Manual

EN
19
Installation
www.bora.com
5.8 Sealing the appliance
1
Fig. 5.24 Silicone sealant in surface mounting
[1] Black, heat-resistant silicone sealant
1
Fig. 5.25 Silicone sealant in ush installation
[1] Black, heat-resistant silicone sealant
XX
Once all of the installation work is complete, seal the
appliance with black, heat-resistant silicone sealant [1].
XX
Make sure that no silicone sealant gets under the cooktop.
5.9 Handover to user
Once installation is complete:
XX
Explain the main functions to the user.
XX
Explain all safety-related aspects of operation and handling
to the user.
XX
Provide the user with the accessories and operating and
installation instructions, which are to be kept in a safe place.
XX
Fasten the cable mounting clips [3] to the designated bore
holes [1] either on the left or right hand side for the cable
routing to the cable opening in the rear wall of the unit.
XX
Ensure that the cable is not trapped or damaged and is not
able to come into contact with any hot hobs.
XX
Check that installation has been carried out correctly.
XX
Switch on the main switch/automatic circuit breaker.
XX
Put the cooktop into operation (see the “Operation” chapter).
XX
Check that all the functions are working correctly.
Appliance power management
(total power reduction)
The total appliance power can be reduced to 4.4 kW upon
initial commissioning if the required electrical power cannot be
provided at the installation site. The connection must always be
equipped with 20 A fuse protection as a minimum.
Programming the appliance power management
The appliance must be switched off for programming and the
childproofing feature must not be activated. Programme the
cooktop within 2 minutes of the cooktop being connected to the
power supply.
XX
To programme, press all 4 cooking zone selection buttons
simultaneously for 3 seconds.
XO
7.4 (factory setting) will appear in the display.
XX
Press the or the button to reduce the total power
consumption to 4.4.
XX
To save, press all 4 cooking zone selection buttons
simultaneously for 3 seconds until a beep is heard.
XO
The beep signals that the settings have been saved and the
cooktop will switch itself off.
The next time it is switched on, the cooktop will be ready for use.
5.7.1 Function test
XX
Carry out a thorough function test on the appliance.
XX
In the event of error messages, see the “Troubleshooting”
chapter.

bora GP4 Specifications

General

Brand	bora
Model	GP4
Category	Cooktop
Language	English