EN
26
Cleaning and maintenance
www.bora.com
1
2 13
Fig. 7.5 Unlocking the activated charcoal lter housing cover
[1] Outer locks
[2] Central lock
[3] Activated charcoal filter housing cover
Removing the activated charcoal filter
1
Fig. 7.6 Releasing the outer locks
[1] Outer lock
XX
Release both outer locks [1].
1
Fig. 7.7 Opening the central locks
[1] Central lock
XX
Release the lock [1] in the centre.
XX
Fold the housing cover down until it clicks into place.
Closing the air guiding housing
1
2
3
4
5
Fig. 7.4 Closing the air guiding housing
[1] Air guiding housing
[2] Sealing groove
[3] Retainer hook
[4] Locking tab
[5] Housing base
XX
Using both hands, position the housing base [5] in such a way
that the locking tabs [4] on the housing base line up with the
retainer hooks [3] on the housing.
XX
Insert the housing base into the sealing groove [2] of the air
guiding housing [1].
XX
Push the housing base [5] upwards until the 4 locking tabs (2
front, 2 rear) click into place on the retainer hooks [3].
XX
Check that all 4 locking tabs [4] have clicked into place correctly.
7.6 Changing the activated charcoal
filter
Two activated charcoal filters will only be fitted with the stainless
steel grease filter if the cooktop extractor is used in recirculation
mode. The activated charcoal filters absorb cooking odours that
arise during cooking.
i
The activated charcoal filters must be replaced when
the fan indicator shows
F
(filter service display). You
can obtain the activated charcoal filter BAKF from your
specialist supplier or by contacting BORA via the website
at www.bora.com.
XX
Make sure that the cooktop and cooktop extractor are
switched off (see chap. 6[1]).
XX
Wait until the fan power level indicator shows
0
.
To Next Page
Loading...
Need help?
General
