EN
22
Functions and operation
www.bora.com
Switching on the automatic after-run function
XX
Continue pressing until the fan level
n
for the automatic
after-run function is displayed.
6.2.5 Filter service display
The filter service display becomes active after the cooktop
extractor has been operated for 150 hours. The activated
charcoal filters are exhausted and the stainless steel grease
filter needs to be thoroughly cleaned.
XO
F
is displayed in the filter service display.
XO
The filter service display is shown every time the cooktop
extractor is switched on and remains active until the filter has
been changed and the filter service display has been reset.
XO
The cooktop extractor can still be operated without limitations.
If you do not wish to change the filter yet because, for example,
you only cook occasionally:
XX
Press or to switch to the normal operating mode.
0
is
displayed by the fan level indicator.
Changing the filter
XX
Switch off the cooktop with integrated cooktop extractor.
XX
Observe all the information provided in the “Cleaning” chapter.
XX
Replace the activated charcoal filter.
XX
Clean the stainless steel grease filter, the air inlet nozzle, the
air guiding housing and the housing base.
Resetting the filter service display
If the activated charcoal filter has been replaced and the
stainless steel grease filter has been cleaned, it will be
necessary to reset the filter service display.
XX
Switch on the cooktop with integrated cooktop extractor.
XX
Press and simultaneously for at least 3 seconds until
a flashing
0
is displayed by the fan level indicator. After a few
seconds the
0
will stop flashing. The filter service display has
been reset.
6.3 Safety devices
6.3.1 Childproofing feature
The childproofing feature prevents the appliance from being
switched on accidentally.
i
If a cooking zone indicator alternates between displaying
L
and
H
, the cooking zone is still hot.
Switching on the childproofing feature
Prerequisites:
XO
The cooktop is switched on.
XO
All cooking zones are switched off.
XX
Press the sensor buttons and simultaneously within
10 seconds of switching on and then press sensor button
again.
L
is displayed by all cooking zone indicators. The
childproofing feature is activated.
Switching off the cooktop extractor
XX
Press and simultaneously until
0
is displayed by the
fan level indicator.
or
XX
Press or several times until
0
is displayed by the fan
level indicator.
If the fan level indicator displays
0
, the cooktop extractor is
switched off automatically after a few seconds.
6.2.2 Power levels
Adjusting the power level
XX
Press to increase the fan level. The fan level sequence is
as follows:
Fig. 6.1 Fan level sequence
XX
Press to decrease the fan level. The fan level sequence is
as follows:
Fig. 6.2 Fan level sequence
6.2.3 Power setting
The cooktop extractor has a power-enhancing power setting.
This power setting makes it possible to suction away high levels
of cooking vapours more quickly.
6.2.4 Automatic after-run
The cooktop extractor continues to run on power level 1 and
switches off automatically after 20 minutes.
To Next Page
Loading...
Need help?
General
